Garage sectional doors series RSD01, are made for mounting in apertures of width up to 3000 mm and height up to 2800 mm. Parameters of garage have to comply with minimal requirements (minimum permissible dimension of lintel is 100 mm, side partition walls – 120 mm). The doors of series RSD01 are produced with low type of lifting. Panels for the doors of this series may be performed in different variants of colour and surface solutions.
Balancing of the doors leaf is performed by means of special balance mechanism located vertically along the tracks to the left and to the right of the aperture. It consists of torsion springs (the springs of tension and compression) calculated on 10000 cycles of opening/closing, and of block and rope balance system. Using of such balance mechanism differentiates in essence the doors of series RSD01 from classic overhead doors with torsion mechanism.
Along the contour of the doors of series RSD01 there is installed a cold-resistant weather seal out of PVC surpassing in its qualities the existing analogs (for example, the doors with imported accessories are not adapted for operation in European climatic conditions. Operation safety of the doors is provided due to the special systems used in its design, such as «spring in spring» and double rope. Garage doors of series RSD01 are easily mounted in two hours.
Recommendations for garage measurement please see in section “Specifications”.
Doors of series RSD01 may be produced with the width from 2000 to 3000 mm and with the height from 1800 to 2700 mm.